This is a 2 piece (printed) swivel hanger. Purchased pieces are required to fully assemble. Parts will be listed below.
4
10
0
66
updated August 9, 2024

Description

PDF

Short back story to this and the sister design short to follow. I adopted a hanging basket that was gifted to my girlfriend. She forgot about it and it was in the path of my nightly chores and it wasn't looking great. I was able to save it but noticed that the area that I hung it up, was half shaded. The shaded half of the plant would always look half dead and so I would unhook it and spin it. Looking for some things to print, I came up with this.

 

It's a 2 piece (printed) swivel with two counter sunk holes in the mount base sized for a #8 screw. 

 

The parts are designed to be imported and should be in the correct orientation to print without supports. There may be a few hanging bridges so supports can be added if desired. 

 

BOM:

1 pc Mounting Base

1 pc Ring

1 pc M3 SHCS 16mm long 

1 pc M3 hex nut 

1pc 623z ball bearing (3mm ID x 10mm OD) 

Tags



Model origin

The author marked this model as their own original creation.

License