Candle Holder

I designed and printed a candle holder to protect my furniture and preserve its new varnish. This is a simple print that can be made using any material, layer height, and infill. The design is intended to hold a candle along with its lid and was specifically created for the larger candles from Bed Bath & Beyond. However, it can accommodate smaller candles as well.

As an additional recommendation, I suggest adding rubber feet to the bottom of the print to prevent it from sliding, though this is not essential.

For reference, my print settings were as follows:

Layer Height: 0.20mm
Infill: 20%
Material: PLA-CF