GEPRC MOZ7 GPS M10Q Mount

Made as a replacement for MOZ7's GPSmount, if you have a GPS M10Q model, 25x25 mm mount. There is a slit for strapping it down with a ziptie for extra security.

Made using fusion 360. 
Printed on Creality CR6-SE. Not really suitable for TPU, But if you slow down your print speed it will mostly be fine. 

Printsettings: TPU Filament 
Nozzletemp: 225 
Bed temp: 50
Speed Print: 40mm/s (both infill and outer layer)
Infill: 80-100  (actual model is 80%, but is slightly too flexible. May differ from TPU filament)
Retraction distance: 6mm
Retraction speed 60mm/s
Suppports: Yes. ( I have not tried without)

Not to be sold!