Bow Attached Quiver (Monarch Recurve or Similar)

This was designed for the Monarch Takedown Recurve Bow, but if your bow has an attachment point with holes spaced 34 mm apart, it should also work just fine. You will need (2) #10-24 x 1/2in screws/bolts. 

IMPORTANT: Printing the part in it's default arrangement is important because layer line orientation makes a big difference in durability. 

You may need to sand/file where the two pieces come together just a bit. You could also glue them together but friction has held them nicely for me so far. 

I based my design off of AstroVest's because I didn't care for how blocky his design was and how it required supports. And I wanted it to hold more than 3 arrows.