EasyDry AMS desiccant master spool #4

source:

https://forum.bambulab.com/t/default-desiccant-melted-and-my-ams-is-sticky/41037/8

https://www.reddit.com/r/BambuLab/comments/171j7o4/what_is_this_strange_clear_liquid_in_the_bottom/

The BambuLab AMS (Automatic Material System) is designed to keep filament dry during 3D printing. However, humidity can still be an issue due to the following factors:

Moisture Absorption by Filament:

• Filament that absorbs moisture can lead to print quality issues, poor layer adhesion, and even nozzle clogging, resulting in failed prints.
• The AMS has an air-tight seal, and with the help of desiccant material, it absorbs moisture to keep it away from the filament.

Tiny Silica Gel Bags Inside the AMS:

• The AMS comes with small silica gel bags (desiccant) to absorb moisture.
• However, these tiny bags may not be sufficient to maintain low humidity levels, especially if the filament spools are wet or the environment is particularly humid.

Solution: EasyDry Spools:

• The “EasyDry” Spools are designed to address this issue effectively.
• These spools allow you to add up to 1 kg of silica gel, significantly increasing the desiccant capacity.
• By using EasyDry Spools, you can maintain a consistently low humidity level inside the AMS, ensuring optimal filament quality and successful prints.

Remember that proper filament storage and handling are crucial for achieving the best results. If you’re experiencing humidity-related issues, consider using EasyDry Spools and monitoring the AMS’s internal humidity levels for optimal performance. 🌟

The spools are very easy to print, i made 4 different version. If you use some filament regular print the spool from this filament so the spool them self acts as filament swatch.

Food safe orange silicat gel

I use the orange one that went dark green if saturated with water and can be unlimited regenerated in 2 - 4 hours with only 110°C this can be done with any convection oven.