OBSBOT Tail Air Remote 'Case' / Side-Cover and Under-desk 'Holster'

1 - A simple cover/slider for the OBSBOT Tail Air Remote to cover the unsightly left-hand face of the remote, without obscuring the USB-C port. Also gives the remote a bit more width, making it nicer to hold. Slider should just snap on. Might need a bit of ‘convincing’, but should be doable.

2 - An under-desk ‘holster’ to stow the remote in an easily-accessible, and out-of-the-way manner. Width is set assuming the above cover/slider is installed; YMMV using this holster without the slider.

I printed both of these in PLA at 0.2 mm layer height with a 0.6 mm nozzle.

Here's a link to the Onshape document I made these in. Feel free to copy it and do whatever you want with it 😊