Burrow Carta coffee table leg

We found a Burrow Carta coffee table in the trash and rescued it! It needed some glue and some legs. You need 8 14mm M6 screws, which I found from Monster Bolts on Amazon in a 10 pack.

I created the set of legs to point to the side. If you flip the table on it's top, the “front right” leg goes in the front right corner, but also the back left corner. The “front left” leg also goes in the back right corner.

I also created a variation which tapers diagonally and is labeled as such.

Tinkercad link here.

I printed in black PLA w/ 30% gyroid infill & 6 top, bottom, and side layers. And I put felt feet on the bottom.

If I were to re-make these, I would increase the diameter of the foot to match the felt feet which I have.

Customized the base to fit the Burrow Carta coffee table.