Victorinox SwissCard pocket knife case replacement

I broke my SwissCard pocket knife case about every 6 months. The small glued joints near the knife seemed to fail first. This is a FDM printable replacement. I have used it for 2 years now without any failures. After printing you can adjust the grip on each tool by warming the outside of the case with a lighter or hot air tool then pressing it in to the installed tool gently. For extra fine adjustment I have gently heated the back of the knife tool and used it to make a small indention over the tool opening to make a retention bump. 

A well calibrated printer is required to achieve the small openings needed for this print. Otherwise, no support or other special settings are required.