Extractor for ENDER fabric enclosure without fan interface

I designed this extractor following the purchase of my enclosure for my Ender 3S1. I realized that my enclosure did not have an interface for a fan.

To install this extractor, you will have to make a hole in the fabric of the enclosure for the extraction of hot air and 4 small ones for the fixings included in the 3D model. the extractor is in two parts, each part is placed on either side of the tissue and compresses the tissue using the fixings

50 MINIMETERS FAN IS REQUIER

3mf files contain all print settings, filament settings.

print settings:

• no bottom layers(infill directly on the plate) 
• 3 top layers
• brim need on the corner at least
• infill 10% (honeycomb)

15/07/2024

screws thread are fix.