[Fully Printed!] Mini Candy Dispenser

Print guide:

The upper and lower body pieces require minor support.

Print 4 of the washers

Make sure to correctly orient the parts

Steps to assemble:

1. After putting glue into the screw hole in the wheel, screw on the front plate with the crank and two washers. See image below and exploded view for more info
2. Hold in place the back piece with the back screw and washers in place
3. While still holding the back in place screw it on, again with glue in the other screw hole of the wheel
4. Using glue, snap the top and bottom pieces into place and fill with candy
5. Put on the top cover (do not glue!)