MTG Commander Deck Box

This is remixed from another commander deck box. I like the original model but needed to make some modifications for my purposes. The primary motivation for this remix was adding a larger commander slot to accommodate larger slide card cases. The ones specifically designed around were the GAMEGENIC ones which measure ~68mm wide by ~94mm tall by ~6mm thick.

Other modifications include increasing the commander card slot cutout to show the card's type line and set symbol, adding an extension to the lid to cover the top of the commander card's sleeve, and reversing the direction the lid is slid onto the box.

The model's in the Hard Sleeves folder are the deck box / lid pair that fit the GAMEGENIC slide card cases. The model's in the Soft Sleeves folder will fit any single sleeved cards that are in any generic soft sleeves.

Note that the model's in the Hard Sleeves deck box / lid pair can also be used to house two commanders that are sleeved in soft sleeves. Useful in cases where the deck has partnered commanders.

Prints well at layer height 0.20mm, 20% infill. No supports are needed.

The following are what differs between the remix compared to the original:

• Swapped the direction the lid is slid onto the box. Used to be from the back now it slides on from the front. This was to accommodate the next change.
• Added an extension to the lid that covers the top of the commander card's sleeve. I disliked how the top of the commander card's sleeve could be seen; especially if the sleeve colour was drastically different from the filament colour.
• Increased the height of the commander card slot cutout to allow you to see the card's type line and set symbol.
• Added a second variation to the box and lid which can accommodate thicker slide card cases.