Label holder - honeycomb storage wall

This model is a label holder to be used as an attachment to the Honeycomb storage wall. I tried to keep the “honeycomb aesthetic”, so it has a bit of a weird shape.

I published two versions with slightly different gap to where the label is inserted.

I have also added a small lip, so it doesn't go in further than required.

Measurements of the label:

• width = 3.8cm
• side =  1.45cm
• top to bottom = 2.23cm
• bottom width = 1.1cm

Recommended settings for printing:

• .4mm nozzle diameter
• .2mm layer height (but .16 looks nicer)
• supports recommended
• brim not required (might be different for you)