Seeed studio reRouter RPi CM4 10-inch Rack Mount

A 10-inch Rack Mount for the Seeed Studio reRouter carrier board for the Raspberry Pi Compute Module 4 (CM4). You can optionally mount up to two SSDs to it.

This particular board can get pretty hot, so I added a heatsink and some holes close to where the CM4 should be. If you have a cooler, it may be a good idea to add it too.

To mount the board, you need to screw it from below, after you put the CM4 into it.

Materials

• 4x M2.5 screws 8mm (For securing the CM4 in place).
• 4x screws and nuts for the cooler, but the size depends on your fan dimensions.
• The reRouter CM4.
• A CM4. Take a look at https://rpilocator.com/ to find one.
• Some passive or active cooling for the CM4, like the one from Waveshare.

Do you like my models? Consider buying me a coffee ;)

Print Settings

Printer Brand:

Anycubic

Printer:

Custom Mega X

Rafts:

Doesn't Matter.

Supports:

Maybe, depending on your bridging.

Resolution:

0.2 or 0.24

Infill:

20%

Filament: 

PLA+/PETG/ABS/ASA/Nylon - Any should be good.

Notes: 

I have added two STLs, one in which you can mount two 2.5-inch SATA SSDs with the reRouter, and another model just for the reRouter.