Vintage Carbon Microphone

A vintage carbon mic, used onstage. This is NOT a functional microphone - it is a prop. This has a threaded base, that screws on to a standard microphone stand (5/8"-27) and fits nicely. The front and back halves are glued together, and the ring is glued to the base. The springs were purchased at a hardware store. The whole thing was then painted. Modeled in Fusion 360.

Print Settings

Printer Brand:

Creality

Printer:

CR-10

No

Supports:

Yes

.2

Infill:

15%

Notes:

I did use supports under the little rings on the inside of the big ring. Just a basic PLA - I often use Hatchbox, but I am not sure what brand I used.