Monier Crockpot Lid Handle With Badge Inset

Our beloved vintage crockpot, is still going strong despite all the brown plastic parts cracking. side handles, feet, and now the lid handle.

I went to glue it, but it split once I turned the screw in.

I did a couple of quick searches, and found one on onshape by Charles Buchanan. I altered a couple of the dimensions, and added the inset for the original badge.

Printed in black ABS as the lid gets quite warm. 

Suggest printing with the wide side down using supports, this should give the best print quality, as the support interface layer will be covered by the badge. My badge ended up press fitting, once I had scraped away the support.

Here is my design if you want to tweak it

increased outer diameter and hole diameter, added inset for badge(label)