Wall Bracket for wider Power Strips (Version 2 up to 59 mm)

This is Version “2” of the wall bracket. It has more space for a power strip of up to 59 mm width (height 42). Please check also my first version of the wall bracket for additional informations.

If have printed the bracket with PLA. This version of bracket needs support in four areas, the overhang there is to big. Please have a look at the attached picture (screenshot PRUSA slicer).

Do you know “Flying” power strips because the cords are too short or clutter on the floor. With this easy to print wall bracket you have a better "home" for a power strip.

Fix it with two or four screws on the wall and place a suitable power strip temporarly in it. I have tested it with some different German types of power strips but not all will fit.

Wenn using the bracket, make sure that the plug or power supply is still unobstructed in the power strip, when this is not possible, don´t use this model of wall bracket and design your own. When use a part for electrical devices please note your local code.

For the design I have used Fusion 360 and the Prusa slicer.