Tweezer Case for Japonesque Tweezers

I recently got a pair of Japonesque tweezers and wanted to challenge myself to model a case for them from scratch.

The top cutout is intended for the Japonesque pointed tweezers and has a raised guard to protect the tip. The bottom is meant for the Japonesque slanted tweezers.

Print Settings:

PLA

0.2 layer height

15% infill

Supports

The hinge is fixed with a length of 1.75mm filament.

The latches are not very effective, so I suggest heating and bending them down to provide more contact between the male and female ends when closed.