Cam Latch

Scaled up Version.  Approximately 60 x 100.  Clearances adjusted, holes changed to accept ¼" hardware.  Tweaked one of the mounts to enable assembly of beefier parts.

I printed in PETG 50% infill triangles.  Auto Support - Trees with 30 degree threshold angle.

The handle (LRG P1) arms were too stiff to flex around the handle mount (LRG P3), so I added some recessed slots to the handle mount to allow the handle to slide on.  This worked well and once on, the handle is still very secure.

I needed a larger latch so I scaled this up to about 60 x 100.

I adjusted the clearances after scaling so they weren't too big/small.

I changed the screw holes and recesses to use ¼" hardware.

I added some relief slots to ease assembly of the larger parts.