Furniture Leg

Because I needed some legs for an IKEA cabinet, I designed these feet/legs to go on each corner to raise it by approx. 24 mm. I mounted the legs with 2 M2x10 wooden screws at each corner to hold it in place.

The model comes in 2 variants; Rounded and Countersunk. The countersunk version is made to fit a Ø15 mm felt pad under it, but the rounded version can also use this, but it wouldn't be as neatly integrated. 

In case the legs need to hold a large amount of weight, it can be necessary to print them very tough. I printed them with the following parameters:

• 5 Walls
• 5 Bottom
• 8 Top
• 40% infill
• No support