Star Wars Jedi Vector (The Acolyte)

The Jedi Vector is the starfighter used by the Jedi Order during the High Republic Era. This is the version used in The Acolyte, about 100 years before episode I. It is the successor of a different Jedi Vector from 100 years earlier.

This model comes in 1:75 and 1:270 scale.

The wings have print-in-place hinges to fold up and down (at both scales).

The 1:75 scale version comes with an articulated stand.

The 1:270 scale version is compatible with a small pin and base.

Print Instructions

1:270

Printed at 0.7mm layer height.

Requires supports on builtplate.

For a holder, print “acolyte vector-1270 pin”. Otherwise print "acolyte vector-1270".

1:75

You can either print it in one or two colors.

If you are concerned about the hinges, you can print “acolyte vector-hinge test” first to test your settings.

One Color

Print “acolyte vector-print body”.

Printed at 0.15mm layer height with supports on buildplate.

My slicer added supports to the inside of the hinges for some reason. If you have the same problem, add “acolyte vector-support blocker” as a support blocker.

I recommend reducing the print speed when the print gets to the wings. Otherwise the wings might wobble or even snap off.

Two Colors

Everything was printed at 0.15mm layer height.

The colors are orange and black. (My print is white and red because I don't have the right filament.)

• “acolyte vector-print body colors”
  • orange and black
  • filament change at 87.5mm
  • requires supports on buildplate
  • add “acolyte vector-support blocker” if your silcer adds supports to the inside of the hinges
  • reduce the print speed when printing the wings.
• “acolyte vector-print front wing”
  • orange and black
  • filament change at 7.4mm.
  • brim recommended
• “acolyte vector-print cockpit”
  • black
• “acolyte vector-print back stripe”
  • black
• “acolyte vector-print nose stripe”
  • black
• “acolyte vector-print underside”
  • black

Stand

The stand consists of two parts.

They were printed at 0.15mm layer height and do not require supports.

• “acolyte vector-stand base”
  • filament changes at 2.15mm and 2.75mm
• “acolyte vector-stand arm”
  • requires good bed adhesion

For Light and Life

If you want to support me, you can do so via this link: https://ko-fi.com/printingdaniel#