Charging Dock for Cordless E-screwdriver

Features

• Uses two screws to attach to the wall
  • Bottom screw is just to keep mount straigth
• Hole in the bottom of the mount for USB-C charging cable

Printing Tips

• Place the mount in the print bed so that the charging cable hole is facing the print bed
• Mount has a curved top surface, so thinner layer height produces nicer finish
• 2-3 perimeters and top/bottom layers should be enough
• 10-30% infill
• No supports or raft required

Charging Cable Installation

1. Push the USB-C charging plug through the hole in the bottom of the mount
2. Connect charging plug to e-screwdriver
3. Push e-screwdriver into the mount as deep as possible
4. Make sure e-screwdriver is not rotated left or right 
5. Pull back e-screwdriver ever so slighty ( this makes sure charging plug makes  a good connection after the glueing.
6. Use hot glue to glue the charging cable with bottom of the wall mount
7. Wait for glue to harden and pull off the e-screwdriver

Wall Installation

1. Screw in the first screw to the wall
2. Adjust the depth of the screw so charging mount can be slid down to it
3. Make sure mount is straight and screw in the second screw

Purchase Wiha Zai Hause Cordless Electric Screwdriver

You can use my affiliate link below to buy electronic screwdriver that fits in this mount:
https://amzn.to/3VOCKXR