BESSEY Small 4 inch F-Clamp Anti Mar pads and Storage Slot

I printed these using Overture PLA Professional with a 0.6 nozzle.  I set walls to 2.

I closed the clamp to snap the pad on.

I have warmed the round pads up before snaping them on.  Sometimes a tab snaps if they are cold. 

Once the pads are on they will stay.

The storage slot will snugly hold the clamp.   I used a Modified Phillips truss head wood screw by “SNUG FASTNERS”  The screw head sits below the surface for mounting.  When printing the storage slot, stand it in end paying attention to ensure the Tear drop point of the screw hole is up so it prints well.

The Fusion 360 file is included.