Reel CooL Drink Holder Fishing Pole Drop Line/Kite Reel

Drink holder fishing pole created with Tinkercad
In the contest Fishing
18
34
0
477
updated July 2, 2024

Description

PDF

REEL COOL The Drink Holder and Fishing Pole/Drop line Combination. (Built from Scratch with TinkerCad)

 

Also great for flying kites

 

I fine tuned this model to print with selected supports and orientations for cleanest and easiest priting results.

 

HIGHLY RECOMENDED TO PRINT THE “BOLT” ALONE WITH NO SUPPORTS AS IT PRINTS BEST WITH A SMOOTH EVEN FLOW

 

EVERYTHING HAS 999 WALLS

Arachne walls .20 Layers, top and bottom surfaces = monotonic line, Thick bridges enabled

 

Reel uses these supports > Normal(Auto) > Snug > Thresh A = 30 > BP Only = unchecked > Rem Sm= checked

**you should be able to grab a portion of the support with pliers and pull it out in large pieces if you grab in one of the larger slots it kind of unravels in its zig zag fashion

 

Cup and guide use these supports > Tree(Auto) > Tree Hybrid > Thresh a = 30 > BP Only = unchecked > Supp Crit = unchecked > Remove Sm= checked

 

Bolt needs no support

 

ASSEMBLY

 

**The line guide is designed to rotate 180 degrees to accomodate left or right handed fishermen

 

1. slide guide over post on cup with curved side towards can it should fit nicely either direction.

2. Slide Reel onto post with handle facing outwards

3. Thread screw gently in at first until it goes out in and out nicely, you can also use a nickle in the slot if you want to help as a screwdriver(use lube if neccesary, but it should run in smoothly if printed alone without supports) the tightness of the screw can be adjusted while fishing to help use as a brake when tighter and let the line out when loosened slightly

 

**Now you can attach your fishing line by feeding it through the eye hole guide on front side and then tying it around the reel and cranking it in with desired amount of fishing line

 

Tags



Model origin

The author marked this model as their own original creation.

License