SilverStone ALTA G1M JBOD backpack + general purpose JBOD shelf

A custom-designed 3D printable JBOD case, perfectly tailored for the SilverStone ALTA series! This sleek and efficient case is designed to accommodate four 3.5" hard drives, providing a stylish and practical storage solution that seamlessly integrates with your SilverStone ALTA case.

For those that do need to place this on their desk, there's a version with legs to provide fan clearance.

Key Features:

• Perfect Fit: Designed to hang off the side of your SilverStone ALTA case, ensuring a secure and space-saving setup.
• Optimized Cooling: Features bottom ventilation with a 12cm fan to ensure adequate airflow, keeping your drives cool and enhancing their longevity.
• Sturdy Design: Very rigid with 20% infill.
• Easy Assembly: Dovetail joins the two halves. No additional hardware is required for mounting. For the fan, I used a Noctua 5V USB powered fan. But any 120mm fan will fit.
• Cable Management: Cables feed out top and right over to external SAS controller. The case leaves some space to feed out power cables form the internal power supply.

Print Settings:

• Material: PLA, PETG, or ABS (depending on your preference and environmental conditions)
• Layer Height: 0.2mm or lower to avoid supports.
• Infill: 20% for strength without excessive material use
• Supports: Print without supports