top_gun_de's "Voron V2.4 and Trident: Y Endstop Relocation" adding a 2-pin JST XH connector

Assembly (from original with some additions): 

• Solder wires to the endstop. Use the two outer pins, don't connect anything to the inner one. If you are unsure about this, check the V2.4/Trident manual, there are instructions for the wiring of the x and y endstop switches. No changes on that procedure.
  • Optional: Use a small piece of heat shrink over the middle pin
• Use 2 M2x10 self-tapping screws to fasten the microswitch in the bracket.
• Push the 2 pin XH connector from the outside into the bracket.  
  • Optional: Use a small dab of super glue if needed to fasten the connector
• Turn out the two front screws for the stepper motor, use M3x35 to attach the bracket. The holes are actually slots for endstop adjustment. I get good results when the bracket is flush with the motor housing.
• Fasten the bumper to the gantry, use the holes and screws that you used for your cable bridge. The mount was designed for the stock screws.
• Connect the male 2 pin connector and run wires to your MCU.

Modified to add a 2 pin XH female connector