45° Wall Mount for Vizio Surround Speakers

Wall mount for Vizio surround speakers that mounts at a 45° angle using the supplied speaker bolts.
6
61
0
267
updated June 30, 2024

Description

PDF

A simple model that allows mounting of Vizio surround sound speakers to the wall at an angle. Mimics the included mount, but at a 45° offset. I found a couple of models online that were for this application, but they did not fit. So I made this as a solution.

Requires a single screw that should be driven into a stud or use an appropriate wall anchor. Make sure to use a flat head screw to mount, not a chamfered screw, as the latter will likely cause the print to split. The screw hole is 4.5mm wide with a 12mm head opening and should support a wide variety. I used a Kreg pocket hole screw, as they have a flat and wide head and can support a decent load.

This is designed to use the bolts that Vizio includes to connect the speaker itself to the bracket. The bolt and speaker just drop into the slot. Note that because the bracket sits very close to the wall, and because it drops down into the bracket, plugging in the wire can be tricky. It's not difficult, but you can't plug in the wire first and then install onto the bracket, because the angle prevents the speaker from being rotated.

My print was done in Overture Matte White PLA using 3 walls and 8% gyroid infill, using a .6mm nozzle and .24mm layer height.

The included model is for the right-rear (when seated) speaker. To print for the left, just mirror the object in your slicer.

Tags



Model origin

The author marked this model as their own original creation.

License