Yet Another Raspberry Pi 5 Four Disk NAS

This project was inspired by this project from Michael Klements,but it's not a remix.

Thanks to step file from Radxa,Raspberrypi,@Waikikiprod,@rohdelabs,which makes the design much easier.

Updated:

Finally I soldered a new 12mm switch button on J2 jumper instead of using the origin one.If you decide to use this solution,please use Pi5_NAS-Case_Bottom_Final.3mf file.

Button Link:

https://www.aliexpress.com/item/1005007090307003.html

Remember to install board first before install the button.

But I've attached the freecad project file for you to make your own remix.

Use 4xM3 heat inserts for screw hole to connect top and bottom part.

4*M2.5*6 screw on the bottom to fasten the board,and some M3 screws to lock the disk.

A 4010 or 4007 is used for cooling,use any method to connect it to +5v/gnd power on the board(or 12V/GND if using a 12V fan).

Print the body in any material is fine but I highly suggest you print the light guide pillar in transparent PETG.

Also refer to this page for better print quality