Wildstyle PTsealer Alternatives: TPU Gasket and Metric O-Ring

This is a modified breechface for the Wildstyle by Sillybutts, that uses a printable TPU gasket instead of a glued o-ring since i didn't want to mess with glue. 

Printing instructions

Print the PTseal as per Sillybutts' instructions, for the gasket i recommend to print it in TPU (obviously) with 5 perimeters (so that it becomes solid).

Assembly Instructions

With the help of a small flathead screwdriver gently push the gasket in its groove, then assemble the Wildstyle as normal.

Update 17/10/2024:

I've updated the gasket design and now it's much easier to insert and to replace if needed. I've also added two versions with increased thickness in case your gasket doesn't seal properly.

Update 15/03/2025:

Added a new version that uses a metric 16mm ID x 2mm cross section O-Ring, since he original version isn't compatible with metric O-Rings

Modified the PTseal model