40 Gramm Crankbait / Wobbler

Instructions

1 - Print both halfs

2 - Insert 4x3 4mm lead BBs to the triangular lead holes

3 - Cut 3 pieces of Filament to use as alignment pins, insert them into the 3 alignment holes. Use epoxy glue to mate the two shells together

4 - Twist some wire ( i use tig filler rod ) to form the linetie and hook hangers

5 - use 5 min epoxy to glue in the hook hangers and line tie

6 - Hang the bait from the linetie and either brush on or dip the bait into UV curing resin, let it drip off so you only have a thin coat and cure it in the sun or under a UV light

7 - Sand the bait as smooth as you want. the resin already makes it near perfect, so minimal sanding is required

8 - Paint the bait to your likings, let the creativity flow, Glue 5mm 3d Eyes in the sockets

9 - clearcoat it either with another layer of clear UV resin or 2 part epoxy

10 - DONE, go out to your favourite spot and catch some pikes!

Design Process

This bait is based on a well known premium bait, works just as the original!