Chicken

This is a “ Remix ” from….    https://www.thingiverse.com/thing:505797

*** If you like the file please make your “ like ”.  Every mark helps me to get a free roll out of Prusa.  Thanks…. ***

I liked the original " Thing " but wasn't fond of the built in support so I removed it.  I also removed the legs / feet and flattened them.  I also increased the size and placed notches in the bottom of the chicken. Insert the legs and with a little dab of glue they'll stay in place.  Once in place and after the glue dried I removed the middle support. The chicken will stand  by itself.  I also took the liberty and modified mine to turn into a " Spring Chicken " that I'm going to hang from my car mirror just for the heck of it. 
Both were done using PLA. The chicken was done in white and finished with some red and yellow paint.  A felt pen was used to hi lite the eyes.  Legs were printed with yellow PLA.
 

15% infill for the chicken and I added my own removable supports. No raft necessary. 
100% infill on the legs printed laying flat with the feet pointed upwards with a raft.  No support was necessary.