Minimal Design Case for TTGO Dev Board (ESP32 )

Minimal two part case for a TTGO Esp32 development board. Still work in progress, had removed two of the buttons for another project. Will update model when new board arrives here.

Mounting holes for the screws are designed in a way that you can screw in a hot screw and it will thread itself. The buttons are part of the case.

Both parts are hold together by the clips. Tolerances need to be tight for a good fit.

Print Settings

Printer:

CR-10

Rafts:

No

Supports:

No

Resolution:

0.2 or 0.1

Infill:

20-40%

Filament: Filamentum PLA Vertigo Grey

Notes:

I print this case directly on glas at 65°C with a brim. The result is a very smooth bottom and top of the case parts.

Can be printed on whatever printer you have. Needs to be dialed in good for the buttons.

Category: Electronics