Bosch MMU4 foot

The original feet of our Bosch MMU4 machine were broken. 
The replacement would have cost 15€+ so I designed new ones

Printed in  “extrudr TPU  flex medium” and I used the “FLEX” setting from prusa slicer with the following adjustments:

• Infill: 0-5% Grid
• Perimeter: 1
• Top perimeter: 3
• Cooling: 30% (otherwise, the print will be too hot, since the speed is very low)

Since my print was not very sticky, I used some foam pads.

Depending on your printer, you might need to check the dimensions of the final print and adjust accordingly.