Chewlix coin return slot

This is a replacement coin return slot for my Chewlix.  There are three provided versions of the slot here:

Chewlix Coin Return - Original
An original, unmodified copy of the coin return slot as measured off the one in my machine.

Chewlix Coin Return - Modified
Based on the above but modified to be a bit deeper and have a rounded bottom slope.

Chewlix Coin Return - Modified - Full Flap
Based on the above but modified to have the coin return flap swing into the machine and not outwards.  This allows you to reach in to get coins.

All of these should be printed at 100% infill via increased wall loops. 

They should be printed facing down as shown in the Fusion360 preview image with tree supports where possible.  

Even with tree supports I found the inside of the slope and top to not print super well.  

These will print well in something like resin.

Please note that I do not know if these will fit a real Vewlix and I do not know if they will fit all of the versions of the Chewlix.

STEP files are included for each so that you can make modifications as necessary for your own setup.