Curtain Bracket

A curtain bracket/hook I made using Fusion 360.

It has 4 pegs that can be hammered into the wall as well as, 4 holes for 1 ½ drywall nails. Altogether, this should prove strong enough to resist being pulled down by cats and other animals. The curtain hook has a diameter of 30mm and should be large enough to hold most curtain rods.

Printed at 0.2 layer height

20% triangular infill

3 walls (But I would go for 5 or more)

please use organic supports, no brim is needed. Set support top contact z distance to 0.35 and bottom contact z distance to 0.1 for easy-to-remove supports.  

Please let me know if it holds up your curtain rod!

(Please note, pictures show V1 of the hook, but V3 is only included. V3 has minor design changes that should make the hook easier and quicker to print without losing support)