Mac Mini Half Width 10" Rack Mount

Remixed version of Chris'  ThinkCentre Tiny shelf to accommodate the larger dimensions of the Mac Mini

Print with support enforcers over the front panel cutout, no supports otherwise. Split version should fit most standard printbeds in two pieces and can be assembled with standard fasteners (I used M3x12 screws and hex nuts.) Print with at least 20% infill and at least 2 perimeters.

(The middle rack in the picture is the most recent version of this model which covers the void under the Mac)

• Resized to fit Mac Mini
• Add slight inset to catch circular foot of Mac Mini and reduce sliding
• Add slight retaining bracket to rear of rack
• Adjusted front panel to fit narrower profile of the Mac Mini
• Adjust screw holes for the wider rack size