Seeed Vision Sensor V2 mount for Adeept Omni-Directional Car Kit

This is a simple model to connect a Seeed vision sensor v2 to an Adeept Omni-Directional Banana Pi PicoW S3 Robot car kit. There's a mounting point at the front of the vehicle where you can attach piece, a mounting point for the Raspberry Pi camera with 4 m2 screws, a channel for the cable cable to go under the device, and screw holes on the back to hold the module.

The print is best printed on its side as no supports are needed.

A very specific use case for this model.

https://www.cranberrygrape.com/mini-projects/face-controlled-robot/

Video of car in use: 

I printed in PETG and used 100% infill for stability (was a quick print either way).