Anycubic Kobra 2 Neo Spool Holder
This is a spool holder designed for the Anycubic Kobra 2 Neo using the 2 threaded inserts at the top of the printer.
51
544
3
1687
updated June 23, 2024
Makes
Comments
Nice spool holder that can help to book lees space for 3D printer on my table. Thank you so much!
hola le imprimiste una guia al filamento en el extrusor? donde encontraste el archivo?
I printed the extra strength version with PLA Pro. I took some tips from the original model on thingiverse and I printed it with 6 walls and 50% infill and turned out quite solid.
View one more comment
@MatiasBurall_1454997 Hey man, I don't speak spanish but from what I understand you're asking for the filament guide. I don't actually use a filament guide but there is a remix of this model that you can find which has a filament guide, or you could print it separately as I remember it was mentioned for that model.
@MatiasBurall_1454997 You can find the remix with a combined spool holder here https://www.printables.com/model/990995-anycubic-kobra-2-neo-spool-holder-with-filament-gu or use the filament guide mentioned in the model's description.
Just so we're clear, I didn't print them but you can try it out.
Do you need to install threaded inserts yourself, or you just screw into the plastic?
View 2 more comments
@that_ambuj_1968272 PLA will only last a few months, but PLA pro will probably be much better. I used PETG on my latest, and its still going strong.
@eellliott_2021713 I don't have PETG right now but a lot of PLA (Pro). I will just increase the perimeters and infill for strength. I'm sure I will last until I buy a good spool of PETG.
I'll be sure to post a make! (edited)
Anyone tried it on kobra 2 pro ?
@Kratulio_744205 It should work, as far as I can tell they all have the same frame
do you need to use the PTFE tubing for for printer still or can it take the filament just by itself? And where did you get your screws and washers from? (edited)
@AydenFord_2284775 For me, the ptfe tubing was difficult to manage. I took it off for easy filament swap, and it isn't really needed for this use case.
@AydenFord_2284775 I had the washers and screws on-hand from amazon, very cheap kit with m3-m6 screws and washers of various sizes
FYI , I wasn't able to change from 3mf to Stl , said program was bad
@Beef2112_1613535 Are you using prusa slicer? Some slicers might bot be able to open 3mf. I can convert the file for you if you would like, just tell me which version you wanted to use