Noctua Airflow Amplifier Base remix

So, I quite liked Lukaku's original design, but I decided to try to improve on it a bit.

Changes

• remodeled mostly by the original dimensions
• overall design a bit sleeker (imo) with filleted edges and a more integrated upper part
• cutout in the baseplate to lower filament usage quite a bit (around 70% of the original)
• indents on the bottom part for rubber feet, see below

Printing and Assembly

Printing is done with no real special settings. Supports for the small cutouts were not needed.

Assembly as usual, you will need the original fan part from Lukaku, threaded inserts and some M3 screws (10 mm worked fine for me, 8 mm should be OK). The rubber feet are optional but I like to keep the fan more stable on my desk. 

Additional Materials for my remix

I used 4x 3M Bumpon SJ5008 rubber feet, see here: 

https://www.reichelt.de/gummifuesse-12-7-x-12-7-x-3-1-mm-schwarz-80-stueck-3m-sj5008-black-p225109.html

Updates

2025-03-17: added variant for 200 mm fans (untested)
2025-04-10: added variant for 120 mm fans

remodeled the whole stand based off of the original dimensions, made it look a bit better and added a cutout on the base for lower filament usage.