SimpleHuman Soap Dispenser Lid

While refilling the SimpleHuman soap dispener, the lid slipped through my fingers, fell to the ground and shattered to pieces…

Question: 
Should I buy a replacement part or design my own lid? After reseaching the price for an original lid (11,95€ + 9,95€ shipping), I had my answer.

With the design I went a complete different route, than the original lid. The goal was, that it's as easy to print as possible and because of that I refused to use a dome style design. 

The only thing you need from the original lid is the O-ring / gasket.

My Print Settings:

Rafts:
No

Supports: 
Yes (Organic supports for the O-ring's deepening with 2mm distance to the model)

Resolution:
0.2

Perimeter:
4

Infill: 
15%
Top and bottom pattern: concentric

Filament:
Extrudr PLA NX2 anthracite

Note: 
I'm not sure, if PLA is the best choice to use with soap. Perhaps you should better use PETG.