Tube Lights

----------------------------------------------

Update (Dec 12/24):

• Added Tube Sconce. A new design that utilizes the acrylic tubes, but cut in half with a 16Bit RGB ring on the top/bottom side.

----------------------------------------------

This is a simple tube light I designed that uses LEDFX to sync to the music played through my PC.

It can be wall mounted and I have it controlled by an ESP32 Wifi Board running WLED, so I can change the colour or effect to whatever I want. 

If it fits on your printer, you can print the whole Tube Light in one shot and just slide the Acrylic tube in after installing the RGB ring and wires. 

If not, just print the two parts and join them together (tolerance is 0.4mm)

Parts:

Esp32 Wifi Board for WLED and LEDFX

50mm O.D Acrylic Tube (25cm long) (Use sandpaper to frost it. 150-220 grit will work)

16Bit RGB Ring (Can substitute for 12Bit → This one is the same dimensions as the 16bit)