ebb36 Mounting w/ Cable Clamp

Please note:

I've designed this while away for work so I haven't had a chance to try it out for myself, but if anyone has a chance to give this a go for me, any feedback would be greatly appreciated!

----------------------------------------------------------------------------------------------------------------

I've had my ebb36 lose connection mid print several times due to the cable not being held in place tight enough, so I made a mount with a proper clamp to ensure that the wires will not move inside the connector. I currently use an old ethernet cable which works fine, but in the future I think I will swap to single core wire to ensure I don't lose connection again.

you will need 4x 3mm heat inserts for the mounting body and some 8mm x 3mm screws for the cover 

Edit: 

I have reshaped the model so that it can be used on both the Mini Sherpa and Orbiter 2.0 extruders. It may need to be tested for other extruders, these are just the two I personally use and have the holes lined up for the ebb36. Let me know if you need another model added!

Edit 2:

I have added a model that supports a strain relief that can be bought here: https://www.aliexpress.com/item/1005007102642439.html?spm=a2g0o.order_list.order_list_main.5.7be11802SrhyCl

Again, I haven't really had a chance to try this all out yet, but it should work pretty well and could help prevent future nasty pulls on the cables? Dunno :)