Ender 3 S1 Pro Stepper cooler

Warning any alterations to your printer or any device can lead to failure modify your device at own risk I am not responsible for any damage done using this model, make sure you have a basic understanding of not only basic wiring but also your printers electronics 

Filament: esun pla+ 

temp : bed 60, hot end:210

using filament Fridays hyper fast Cura profile witch I have changed a lot to suit The S1 pro but the high quality the better but Low quality will do fine

Needs supports as seen in photo above

you can use tape to seal fan in as well for slightly better air flow (not needed though)

Will require slightly longer screws for stepper motor mount I just used extra parts given when I got my printer

Please give credit to Lucas Grilli for his amazing model please also look at all of his other great models

This model helps cool the rear stepper motor which can get very hot real quick, it is a remix of another model by Lucas Grilli but in his model the build plate alignment screw hit the left side of the model due to my silicon bed spacers I installed the original part also rubbed against the bottom of the heat bed witch I also fixed this part also allows for a small heat sink to be placed on the left of the stepper for extra cooling power witch I recommend.

Stopped the build plate alignment screws from rubbing on the part and edited all side to make it stronger, more secure and have better cooling power and more modular and easy to edit my model to fit any custom ender 3 s1 or s1 pro