Simple / basic carpet spike for Ikea Lack table

Just a simple model to screw to the bottom of an Ikea Lack table, to save your carpet a little from being crushed by the weight of our lovely 3D printers.

I would like to think it helps to keep the whole table more ‘grounded’ as the table becomes more connected to the floor underneath, rather than everything wobbling a little from the bounce in thick carpet… of course, that's my opinion and could be totally wrong?

Hopefully it comes in use for someone else out there.

I printed these with the following settings:-

• 4 walls
• 30% infill
• 0.2mm layer height

Thanks

Please Like, Download and post your Makes so I can see how it works for you.

Thanks