XTool D1 Pro honeycomb holder that fits within enclosure plus 1 in leg extensions

Holders to center the honeycomb plate under the laser for the XTool D1 Pro. These holders fit inside the enclosure allowing the enclosure to sit flat on the table. I have also included 1 inch risers to lift the machine so that the height of the laser over the honeycomb is the same as the height for the machine with out the honeycomb and risers. The 2 in risers from X-tool fit on top of the 1 in risers for additional height. You could also print another set of 1 in risers for just a little additional height.

I printed mine in PLA using a 0.6 mm nozzle and a 0.4 mm layer height. Any material or nozzle should work fine. Print 2 of each holder and 4 risers. Holders go in opposite corners.