Remix of moon lamp as wall mounted

I love the moon lamps, but my daughter wanted one as wall mounted.

I started with the “Progressive Detail Moon Lamp with Rechargeable Moon station by moononournation” on Tinkercad as it has a great threaded base.

You need to print the lamp part at 130% to match the base.

The base is designed to take an E14 SES light fitting, attached using a 10mm threaded bolt and nut. For my bulb I had to trim the top of the light fitting as you can see in one of the photos, wont be necessary for all.

The 2 small holes on either side of the cable exit are for a cable tie to hold it securely in place.

I Included 2 countersunk screw holes.

If anyone can tell me how to get the 10mm threaded tube to print at the correct pitch, I would like to add that to the model also, thus requiring one less part. But when I tried the tinkercad threaded bolt at 10mm it doesnt thread with the light fitting.

This is the light fitting used, just in white. https://www.amazon.co.uk/gp/product/B08C7DQ5XL

Original model:

https://www.thingiverse.com/thing:3444020

Under the same Creative Commons - Attribution - Non-Commercial - Share Alike license.

It was created with Tinkercad.