Paint Stencils For Fence or Wall

I wanted to add something unique to a fence I recently put up. It'd probably be better to use a different type of paint other than spray paint, but I used what I had on hand. The templates may clog after a few uses, so give them a wipe down before the paint starts to dry.

Included are paint templates for the butterfly, bee, dragonfly, and grass in the following sizes:

• 170mm
• 210mm
• 250mm 

These should fit most mini printers, up to standard size printers. the 250's will fit on bambu plates but you may need to manually adjust placement to avoid the exclusion zone.

These are 0.8mm thick, so 4 layers at 0.20 layer height. you could probably make them 0.4 or 0.6mm thick on Z to speed up the print time.

**Make sure “detect thin walls” is enabled or else the butterfly pattern stencil will be missing some lines with a 0.4 nozzle. Also I recommend slowing down the prints a bit just to make sure the fine details didn't get messed up, especially on the first layer, but feel free to use what you're comfortable with!**