Mechanical Rose (HueForge)

This is my first foray into creating an artwork for HueForge and then printing it. I hope you like it. 

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.24mm
The Max Depth is 2mm and the Actual Depth is 1.9mm

Filaments Used:
PLA Giantarm Matte Navy Blue Transmission Distance: 1
PLA Overture Professional Pink Transmission Distance: 3
PLA BambuLab Basic Orange Transmission Distance: 5
PLA Sunlu White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
Start with Navy Blue
At layer #9 (0.8mm) swap to Pink
At layer #13 (1.12mm) swap to Orange
At layer #14 (1.2mm) swap to White for the rest.