AE B6.4 & B7 Thumb Pro Camera Mount

The B6.4 mount is designed to work with my rear tower guard but can be used without it. The B7 mount can be mounted with 5mm longer screws for the rear wing mount. You can also add one more zip tie around the top of the tower if it needs more support. This part should be solid TPU and everything just mounts zip ties or screws. You can leave the camera mounted and just pull the shock mount nut to access the USB port and get files off the camera. 

On the B6.4 you will need to trim off some of the rear of the body for the camera to fit. The tower was narrow so vertical mount was the only way to fit it. 

The camera is a Runcam Thumb Pro (new version) https://shop.runcam.com/runcam-thumb-pro/

I used this 5v regulator to power it from the receiver. https://a.co/d/bAc38a8

This camera will save a gyro data file which can be imported into Gyroflow with the video file to apply accurate motion smoothing. https://gyroflow.xyz/

You can check out a video of this setup on my TLR here: