LOOKINGBACK-HUEFORGE

Project: LOOKINGBACK-HUEFORGE.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 165.65x236.27mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Matte Ice Blue Transmission Distance: 3.5
PLA BambuLab Basic Orange Transmission Distance: 5
PLA PolyLite White Transmission Distance: 5
This print uses 5 unique filaments

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Red
At layer #12 (1.04mm) swap to Ice Blue
At layer #15 (1.28mm) swap to Orange
At layer #20 (1.68mm) swap to White for the rest.
 

• THIS MODEL USES 5 COLORS, BUT IF YOU DON'T WANT TO ADD THE PAUSE YOU CAN ALWAYS JUST USE ORANGE IN THE PLACE OF THE RED. IT COMES OUT JUST AS GOOD, I JUST LIKED THE LITTLE POP THE RED GAVE IT.