Hanging Umbrella 30mm (ID) Tube Extensions for Clip-on LEDs

A friend of mine has a hanging umbrella for an outdoor table at which they often play cards and dominos at night.  He bought a clip on LED light similar to the one linked below but it was mounted above the runners and too high.  This is an extension that replaces the end cap on his umbrella tube and allows them to mount the lights in a better location.

Holes in the item are to allow either passing through a cord OR to tie a safety wire.  Bottom hole also allows for any water ingress to drain.

Printed in Polymaker Polylite ASA (for UV resistance), 0.4 nozzle on a Bambu Labs P1S.

Uploaded files for 75mm long and 150mm long.  Fusion export is attached and the length is easily adjusted by altering the 2nd extrusion command.

https://www.amazon.com/OYOCO-Umbrella-Brightness-Cordless-Umbrellas/dp/B01N9HR1SX